Secure OT Access - On-Prem ISO Installation

Prerequisites

• Secure OT Access ISO
• License file
• USB pen
• Cable: serial port to laptop

lsblk  (note partition)

 dd if=/dev/zero of=/dev/((partition)) bs=1M count=1000

 sudo poweroff

ISO Installation

Steps to install Secure OT Access:

1. Make a bootable USB pen with a Secure OT Access ISO (NAS_US:/builds/development/singlekey6/appliance/otfuse), we recommend rufus software to do so.
2. Turn on Secure OT Access appliance with the pen and connected through serial port.
3. When CLI is up, after inserting user and password, type _devicebuilder and select the Secure OT Access SKU option corresponding with your hardware, then accept when requested.
4. Type halt, and wait until it shuts down (NOT reboot).
5. Remove pen and serial port, connect Secure OT Access to your network through port 0 (In case using Virtual Machine, please disconnect the ISO) and turn it on again.
6. Access to 10.10.10.10:8443 using a browser connected to the same network and include license.
7. Configure IP in Network settings and reboot appliance.
8. Secure OT Access Management console should be ready in the IP you just configured, in port 443.