Upgrading from a previous version

Upgrading from a previous version on Unix-based deployments

Preliminary notes

Upgrading is usually a two-step process:

  1. upgrade the mdss package by installing the newer package
  2. upgrade the existing code by downloading new images

Acquire the installer package

In order to acquire the new package please visit https://www.opswat.com/solution

In case of an offline deployment, the MDSS offline package also has to be acquired from here: https://metascanbucket.s3.amazonaws.com/Metadefender/MetaDefender_Secure_Storage_resources_v3/latest/deployment.zip

In this scenario the upgrade steps below have the following changes:

  1. Updating packages might not work when offline, this can be skipped if the packages are already up to date.

  2. Before running the installer, the offline package must be loaded with docker load -i <extracted_archive_path>\mdcs.tar as in the offline installation steps.

  3. The sudo mdss -u update command is replaced with sudo mdss -c start since the update has been performed with the offline package.

Debian / Ubuntu package (.deb)

  1. Update your packages
Copy
  1. Move to the folder containing the installer and install it
Copy
  1. Start the service
Copy
  1. Optionally, you can check the status using the following command:
Copy
  1. Open a browser and navigate to the web interface: http://<server> to configure your deployment.

Red Hat Enterprise Linux / CentOS package (.rpm)

  1. Update your packages
Copy
  1. Move to the folder containing the installer and install it
Copy
  1. Start the service
Copy
  1. Optionally, you can check the status using the following command:
Copy
  1. Open a browser and navigate to the web interface: http://<server> to configure your deployment.

Upgrading from a previous version on Windows-based deployments

Upgrading from v2.1.3 or below

Before your upgrade, please verify your docker and docker-compose version by running the following commands:

  • docker -v
  • docker-compose -v

If your docker version is below 20.10.3 please run the following commands in order to upgrade your docker installation:

  1. Upgrade to the latest available version
Copy
  1. A restart is required for the installation to complete
Copy

If your docker-compose version is below 1.28.5 please run the following command in order to upgrade your docker-compose installation:

Copy

Before you proceed, verify that your docker install was upgraded by running docker -v and docker-compose -v again. If everything looks good, please proceed by running the new installer.

Upgrading from v2.1.4 or above

To upgrade from a previous version, running the new installer is enough. The installer will walk you through the installation wizard.

Upgrading from v2.1.5 or below

When upgrading from v2.1.5 or older versions, a warning box may pop up with the following message:

Service 'MetaDefender for Secure Storage' (mdss) could not be stopped. Verify if you have sufficient privileges to stop system services.

The issue and the steps to solve it have been documented here.

Type to search, ESC to discard
Type to search, ESC to discard
Type to search, ESC to discard