Too Many Sockets or Files Open

Only on Linux systems: if too many sockets or files are open by the process this can cause problems.

How to detect

Check the file descriptor limit:

ulimit -n

Check the used file descriptor count on a running process:

watch -n 1 "ls /proc/\`ps -eo comm,pid | awk '\$1 == \"ometascan\" { print \$2 }'\`/fd | wc -l"

If the count is close to the limit this will cause problems.

Rule of thumb: 1 scan workflow requires 2-3 file descriptors.

Increasing the number of file descriptors

The command ulimit -n displays the current set number of maximum file descriptors. In order to increase this number follow the next steps:

Append this line to /etc/sysctl.conf

fs.file-max = 65535

Add the following lines to /etc/security/limits.conf

* soft proc 65535 * hard nproc 65535 * soft nofile 65535 * hard nofile 65535

Restart the system to apply the new configuration. After restart you can check the changed limit by issuing ulimit -n

> ulimit -n > 65535

Last updated on

Was this page helpful?